Envoy 2WD L6-4.2L (2008)
Important: The crankshaft rear oil seal housing must be installed within 10 minutes from when the sealer is applied.
3. Apply a 3 mm (0.12 in) bead of sealant (1) to the following:
*
The crankshaft rear oil seal housing, where the housing meets the engine block
*
The surface of the crankshaft rear oil seal housing, where the housing meets the oil pan
*
The surface of the oil pan, where the oil pan meets the housing
Refer to Sealers, Adhesives, and Lubricants (See: Specifications/Sealers, Adhesives, and Lubricants) for the correct part number.
4. Install the J 44219 guide pins (1) into the block.
Important:
*
When installing a new seal, use the plastic installation sleeve supplied with the new seal.
*
The seal installation sleeve should come off after the seal is installed. Discard the sleeve.
5. Slide the crankshaft rear oil seal housing over the alignment pins J 44219 and crankshaft.
6. Install the crankshaft rear oil seal housing bolts, except the 2 in place of the guide pins.
7. Remove the J 44219 guide pins.
Notice: Refer to Fastener Notice .
8. Install the remaining 2 crankshaft rear oil seal housing bolts.
Tighten all the oil seal housing bolts to 10 N.m (89 lb in).
