Envoy 2WD L6-4.2L (2008)
1. Install the recirculation actuator.
2. Install the air inlet assembly.
Notice: Refer to Fastener Notice.
3. Install the recirculation actuator screws.
Tighten the screws to 1.9 N.m (17 lb in).
4. Connect the recirculation actuator electrical connector.
5. Install the HVAC module assembly.
6. Recalibrate the recirculation actuator on vehicles equipped with automatic climate control (C68). Refer to Actuator Recalibration. See: Testing
and Inspection/Programming and Relearning
Mode Actuator Replacement - Console
Mode Actuator Replacement - Console
Removal Procedure
1. Remove the console.
2. Remove the screw from the air outlet duct.
3. Remove the air outlet duct from the console.
4. Remove the rear mode actuator retaining screws.
5. Remove the rear mode actuator.
Installation Procedure