Envoy 2WD L6-4.2L (2008)
Air Duct: Service and Repair
Air Distributor Duct Replacement
Air Distributor Duct Replacement
Removal Procedure
1. Remove the instrument panel (I/P) assembly.
2. Remove the driver side air distributor duct screws.
3. Remove the air distributor duct (1) from the I/P.
4. Unclip the radio antenna wire from the duct
5. Remove the air temperature sensor from the duct.
Installation Procedure
1. Install the air distributor duct (1) to I/P.
Notice: Refer to Fastener Notice.
2. Install the retaining screws to the air distributor duct.
Tighten the screws to 1.9 N.m (17 lb in).
3. Install the air temperature sensor to the air distributor duct.
4. Clip the radio antenna wire to the duct.
5. Install the I/P assembly.
