Envoy 2WD L6-4.2L (2008)
5. Remove the rear axle fill plug.
6. Fabricate a dipstick from a pipe cleaner of similar item. Form the pipe cleaner into the shape of an "L".
Important: Ensure the pipe cleaner is resting on the bottom threads of the fill hole.
7. Insert the pipe cleaner into the fill plug opening with the stem of the "L" facing down.
8. Inspect the lubricant level.
The lubricant level should be between 15-40 mm (0.6-1.6 in) below the fill plug opening.
9. If the level is low, add lubricant until the level is within specifications. Use the proper fluid. Refer to Sealers, Adhesives, and Lubricants (See:
Transmission and Drivetrain/Differential Assembly/Specifications/Fluid Type Specifications) .
Notice: Refer to Fastener Notice .
10. Install the rear axle fill plug.
Tighten the rear axle fill plug to 33 N.m (24 lb ft).
11. Lower the vehicle.
