Envoy 2WD L6-4.2L (2008)
Vehicle Speed Sensor: Service and Repair
Vehicle Speed Sensor Replacement
Removal Procedure
1. Remove the harness connector.
2. Remove the bolt (2).
3. Remove the vehicle speed sensor (1).
4. Remove the O-ring seal (3).
Installation Procedure
1. Install the O-ring seal (3) on the vehicle speed sensor (1).
2. Coat the O-ring seal (3) with a thin film of transmission fluid.
3. Install the vehicle speed sensor (1) into the transmission case.
Notice: Refer to Fastener Notice .
4. Install the bolt (2).
Tighten the bolt to 11 N.m (97 lb in).
5. Connect the wiring harness electrical connector to the vehicle speed sensor.
6. Refill the fluid as required.
