Envoy 2WD L6-4.2L (2008)
6. Install the shock absorber nut.
Tighten the shock absorber nut to 45 N.m (33 lb ft).
7. Remove the shock absorber assembly (2) from the J 45400 (1).
8. Remove the pieces of heater hose from the front spring.
9. Install the shock absorber assembly in the vehicle. Refer to Shock Absorber and Spring Assembly Replacement (See: Shock Absorber and Spring
Assembly Replacement) .
10. Install the shock module yoke to the shock absorber bolt. Refer to Front Shock Absorber Yoke Replacement (See: Front Shock Absorber Yoke
Replacement) .
11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
12. Lower the vehicle.
Front Shock Absorber Yoke Replacement
Front Shock Absorber Yoke Replacement
Special Tools
J 24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
Important: The lower control arm must be supported so that the ball is not over extended.
3. Support the lower control arm with an appropriate jack stand.
4. Remove the shock module yoke to lower control arm mounting nut.
