Envoy 2WD L6-4.2L (2008)
3. Shift assembly to the LOW position.
4. Loosen and remove the screw at the rear of the shiftier assembly.
5. Shift the assembly to the NEUTRAL position.
6. Loosen and remove the top screw of the shift lock actuator through the lever slot.
7. Pull lever to the DRIVE position and remove the shift lock actuator.
Installation Procedure
1. In DRIVE position, depress the shift lock actuator button and realign into the shifter lever.
2. Push lever to NEUTRAL.
Notice: Refer to Fastener Notice .
3. Install the top screw through the lever slot.
Tighten the actuator screw to 1.65 N.m (15 lb in).