Envoy 2WD L6-4.2L (2008)
Shift Cable: Service and Repair
Range Selector Lever Cable Replacement
Range Selector Lever Cable Replacement
Removal Procedure
1. Ensure that the vehicle is in the park position.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the end of the range selector cable from the transmission range selector lever ball stud (6).
4. Remove the retainer (5) from the range selector cable.
5. Remove the range selector cable (4) from the bracket (1).
6. Remove the cable from the retainer (3) on the floor panel. If the vehicle is equipped with 4WD, remove the cable from the retainers located on the
transfer case.
7. Push the cable grommet (2) up through the floor panel.
8. Lower the vehicle.
9. Remove the console. Refer to Console Replacement .
10. Remove the drivers side front mat and carpet. Refer to Front Floor Panel Carpet Replacement .