Envoy 2WD L6-4.2L (2008)
1. Install the transmission control.
Notice: Refer to Fastener Notice .
2. Install the transmission control bolts.
Tighten the transmission control bolts to 25 N.m (18 lb ft).
3. Install the range selector cable (2) to the floor shift control.
4. Install the end of the range selector cable (1) to the transmission control ball stud.
5. Connect the shift lock control solenoid wiring harness.
6. Install the front floor console. Refer to Console Replacement .
7. Check for proper operation of the floor shift control.
8. Adjust the range selector cable if necessary. Refer to Range Selector Lever Cable Adjustment (See: Shift Linkage/Shift Cable/Adjustments) .
