Envoy 2WD L6-4.2L (2008)
9. Install the J 8614-01 as shown.
10. Remove the pinion nut while holding the J 8614-01 .
11. Remove the washer.
12. Install the J 8614-3 (2) and the J 8614-2 (3) into the J 8614-01 (1) as shown.
13. Remove the pinion yoke by turning the J 8614-3 (3) clockwise while holding the J 8614-01 (1).
Use a container in order to retrieve the lubricant.
14. Remove the pinion oil seal. Use a suitable seal removal tool. Do not damage the housing.
Installation Procedure
1. Install a new pinion oil seal using the J 33782 , 8.0 inch axle or the J 38694 8.6 inch axle.
2. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the splines of the pinion yoke.
3. Install the pinion yoke.
