Envoy 2WD V6-4.3L VIN W (1998)
2.
insert the square end (rounded end will not work) of the metal ruler, between the bottom of the magazine and the magazine opening, at a point
where the ruler is centered over the right edge of the EJECT button. See Figure 2.
3.
Slowly push the ruler straight inward. When it has been inserted approximately 114.3 mm (4-1/2 in), the ruler will stop when it touches the latch
mechanism.
4.
While lightly maintaining pressure between the ruler and the latch mechanism, slide the free end of the ruler to the right in the magazine opening.
When the ruler has traveled about 50 mm (2 in) to the right, apply a little firmer pressure. The ruler will trip the latch mechanism and the magazine
will eject slowly.
5.
Gently pull the magazine and the ruler slowly out of the CD Changer. The CD Magazine should pull out easily. If it does not, do not use force.
Return the CD Changer with the Magazine and CD to an authorized AC Delco(R) Service Center with the completed information Form For
Returning CD's. See Figure 4.
Correction for End Load Models
Remove the magazine from the CD Changer manually following the Service Procedure below. See Figure 3.
Service Procedure
1.
Open the CD Changer door.
2.
Insert the rounded end (square end will not work) of the metal ruler between the bottom right most corner of the CD Changer magazine opening
and the CD magazine. See Figure 3.
3.
Slowly push the ruler inward. When it has been inserted approximately 69.85 mm (2-3/4 in), the ruler will trip the latch mechanism and the
magazine will eject slowly.
4.
Gently pull the magazine and the ruler slowly out of the CD Changer. Identify the part number of the magazine. The part number is printed on the
bottom side of the magazine in white numerals. If the magazine part number is 16255525, replace with new part number 09372325.
5.
Inspect the inside of the CD Changer and determine if a white magazine tray and/or CD has remained in the CD Changer.
^
If the CD Changer does not contain a white tray and/or CD, the procedure is done.
If the CD Changer contains a white tray and/or CD, continue.
^
To remove a magazine tray from inside the CD Changer: Using the index and middle finger, pinch the white tray gently and slowly pull it out
of the CD Changer. If the tray does not come out easily, the tray is jammed. In this case, send the CD Changer along with any CD's and white
trays to an authorized AC Delco(R) Service Center. Enclose the completed Information Form For Returning CD's. See Figure 4. The
authorized AC Delco(R) Service Center will remove the CD(s) and send them directly to the person listed on the Information sheet.
^
To remove a CD in the clamped position, inside the CD Changer: Depress the EJECT button and wait approximately 10 seconds for the CD
Changer motor to stop cycling. Using the index and middle finger, pinch the CD and gently and slowly pull the CD out of the CD Changer.
