Envoy 2WD V6-4.3L VIN W (1998)
^
The headlamps are turned ON manually.
^
The ignition key is removed.
Refer to Audible Warnings for more information.
Seat Belt Reminder
A chime will sound for 6 seconds when the following actions occur:
^
The ignition switch is turned from the OFF position to the RUN position.
^
The seat belt is unfastened.
The seat belt telltale on the Instrument Panel Cluster (IPC) will also turn ON.
Refer to Audible Warnings for more information.
Turn Signal Reminder
A chime will sound when the right or left turn signal is turned ON for more that 0.75 miles. The chime will be synchronous with the turn signal
flasher.
Refer to Audible Warnings for more information.
Battery Rundown Protection
The battery run down protection provides protection against the following conditions:
^
Parasitic loads
^
Excessive battery drain
^
High current loads that are related to the courtesy lamp circuit
The battery run down protection will also protect the battery against being run down from the courtesy lamp circuit to a level that will prevent the vehicle
from starting. The BCM will turn OFF the courtesy lamp circuit when the following actions occur:
^
The ignition switch is turned from the RUN position to the OFF position.
^
20 minutes elapses without a lamp request input.
Complete one of the following actions in order to return the BCM to normal operation when the battery run down protection turns OFF the interior
lamps:
^
Turn OFF all of the lamps and close all of the doors.
^
Turn the ignition switch from the OFF position to the ON position.
Light State
The Daytime Running Lamps (DRL) turn ON when the following conditions exist:
^
The headlamp switch is set to the AUTO position.
^
The sensor is in the LIGHT state.
If you set the park brake, the DRLs will turn OFF. When you release the park brake, the DRLs will turn ON.
The following actions occur it the DRL is set to the PARK LAMP position:
^
The DRLs turn ON.
^
The park lamps turn ON.
The following actions occur if the headlamp switch is set to the HEADLAMP position:
^
The DRLs are OFF.
^
The park lamps are ON.
^
The headlamps are ON.
The following actions occur if the headlamp switch is set to the HEADLAMP position and the HIGH/LOW beam switch is toggled:
^
The DRLs are OFF.
^
The park lamps are ON.
^
The headlamps are ON.
^
The HIGH/LOW beams will toggle with the HIGH/LOW switch.
If the headlamp switch is set to the AUTO position and the and the ambient light level conditions change to DARK for 15 seconds, the BCM will turn
ON the headlamps.
Dark State
The following actions occur is the headlamp switch is set to the AUTO, PARK LAMP or HEADLAMP position:
^
The DRLs are OFF.
^
The park lamps are ON.
^
The headlamps are ON.
^
If you toggle the HIGH/LOW beam switch, the HIGH/LOW beams will toggle.
