Envoy 2WD V6-4.3L VIN W (1998)
Use a flat-bladed tool in order to carefully pry the cover up at the front leading edge.
3. Disconnect the electrical connectors from the switches, if equipped.
4. Remove the switches from the switch mounting panel, if equipped.
INSTALLATION PROCEDURE
1. Install the switches to the switch mounting panel, if equipped.
2. Connect the electrical connectors to the switches, if equipped.
3. Install the power accessory switch mounting cover to the door.
4. Position the cover and snap the cover into place.
5. Connect the negative battery cable.
Power Window Motor
Caution: Sector gear must be locked into position. Regulator lift arm is under tension from the counterbalance spring and could cause personal
injury it the sector gear is not locked in position.
Removal Procedure
1. Remove the window regulator.
2. Drill a hole through the window regulator and the sector gear.
3. Install a bolt and a nut through the hole in order to lock the sector gear in position.
4. Drill out the rivets that secure the power window motor to the window regulator.
5. Remove the power window motor from the window regulator.
Installation Procedure
1. Install the power window motor to the window regulator.