Envoy 2WD V6-4.3L VIN W (1998)
20.
Install the new inner console cover to the outer console cover.
21.
Install the three phillips head screws (2) and then the six torx head screws (1). Tighten all screws to 1.5 Nm (13 lb in).
22.
Close the console cover and verify that the latch operates properly.
23.
Install the console in the vehicle.
24.
Install the bolts that attach the console to the floor and tighten to 10 Nm (88 lb in).
25.
Connect the electrical connector at the right front side of the console.
26.
Install the trim cover over the electrical connector.
27.
Connect the electrical connector at the side of the shifter.
28.
Install the shifter trim plate or bezel.
29.
Install the rubber mat and the convenience tray and close the compartment cover.
30.
Install the GM Campaign Identification Label.
