Envoy 2WD V6-4.3L VIN W (1998)
Wheel Cylinder: Service and Repair
Wheel Cylinder Replacement
REMOVAL PROCEDURE
1. Remove the brake linings. Refer to Brake Shoe Replacement.
2. Disconnect the brake pipe.
3. Remove two bolts.
4. Remove the wheel cylinder.
INSTALLATION PROCEDURE
1. Install the wheel cylinder.
2. Install two bolts.
^
Tighten the bolts to 13 Nm (115 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Connect the brake pipe to the wheel cylinder.
^
Tighten the brake pipe fitting to 18 Nm (13 ft. lbs.).
4. Install the brake linings. Refer to Brake Shoe Replacement.
5. Bleed the brake system. Refer to Hydraulic Brake System Bleeding in Hydraulic Brakes.
