Envoy 2WD V6-4.3L VIN W (1998)
^
Tighten the nuts to 40 Nm (30 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the magnesium beam.
4. Position the pushrod on the brake pedal.
5. Install the switch and the retainer to the brake pedal.
6. Install the vacuum hose on the vacuum booster.
7. Gauge the booster rod. Refer to Brake Booster Push Rod Gauging Procedure.
8. Install the master cylinder. Refer to Master Cylinder Replacement.
9. Install the master cylinder nuts.
^
Tighten the nuts to 36 Nm (27 ft. lbs.).