Envoy 2WD V6-4.3L VIN W (1998)
1. Place the hose clamps loosely on the ends of the hoses.
2. Connect the hoses to the radiator.
3. Connect the lower radiator outlet hose to the water pump.
4. Connect the upper radiator inlet hose to the coolant outlet.
Position the upper radiator hose around the generator (as shown).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Tighten the service type radiator hose clamps, if used.
^
Tighten the radiator hose clamps to 3.0 Nm (22 inch lbs.).
6. Refill the system with coolant to the proper level.
7. Inspect the cooling system for leaks.
