Envoy 2WD V6-4.3L VIN W (1998)
5. Install the fender wheelhouse extension.
6. Install the front tire.
7. Raise the vehicle.
8. Connect the exhaust pipe to the exhaust manifold.
9. Lower the vehicle.
NOTICE: Refer to Fastener Notice in Service Precautions.
10. Install the radiator inlet hose support bracket and nut.
^
Tighten the radiator inlet hose support bracket nut to 36 Nm (27 ft. lbs.).
11. Connect the ECT gauge sensor electrical connector.
12. Connect the EGR valve inlet pipe to the exhaust manifold.
^
Tighten the EGR valve inlet pipe exhaust manifold nut to 30 Nm (22 ft. lbs.).
13. Install the intermittent steering shaft.
