Envoy 2WD V6-4.3L VIN W (1998)
3. Place the washer (3) from the J 42126 tool kit onto the body of the J 33013-B.
4. Remove the center screw from the body of the J 33013-B.
5. Install the center screw into the opposite end of the J 33013-B.
6. Back the body of the J 33013-B off enough to allow the center screw to be threaded onto the end of the compressor shaft.
7. Thread the center screw several turns onto the end of the compressor shaft.
Do not tighten the center screw on the compressor shaft.
8. Hold the center screw with a wrench.
9. Tighten the hex portion of the J 33013-B body several turns.
10. Remove the J 33013-B from the clutch rotor and bearing assembly.
12. Install the clutch rotor and bearing retaining ring (3) using external snap ring pliers (1). Make sure that the camphor side of the retaining ring is
facing up when the retaining ring is being installed.
13. Install the clutch plate and hub assembly.
14. Remove the compressor from the J 41790.
15. Install the compressor into the vehicle.
