A/C High Pressure Cut-Out Switch - Repair & Service Guide
Refrigerant Pressure Sensor / Switch: Service and Repair
Pressure Cycling Switch
Removal Procedure
1. Raise and suitably support the vehicle.
2. Disconnect the A/C control switch connection.
3. Remove the A/C control switch.
Installation Procedure
Important: Counterhold the compressor/condenser hose using a wrench.
1. Install the A/C control switch:
-
Use new O-rings.
-
Lubricate the new O-rings using mineral oil, 525 viscosity.
Tighten
Tighten the A/C control switch to 7 N.m (62 lb in).
2. Connect the A/C control switch connector.
3. Lower the vehicle.
