Envoy 2WD V6-4.3L VIN W (1998)
7. Apply sealant to the oil fill plug threads. Use Teflon GM P/N 1052080, or the equivalent.
8. Install the oil fill plug.
^
Tighten the oil fill plug to 41 Nm (30 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
9. Remove the safety stands.
10. Lower the vehicle.
Fluid Replacement
REMOVAL PROCEDURE
^
Tools Required
-
J 36511 Oil Fill/Drain Plug Hex Bit (117 mm)
1. Raise the vehicle.
IMPORTANT: Drain the transmission after a short period of operation when the oil is warm. This allows any existing fluid in the system to be
expelled when the oil is drained.
2. Support the vehicle with safety stands.
3. Thoroughly clean around the fill plug and the oil drain plug.
4. Use the J 36511 in order to remove the oil fill plug.
