Envoy 2WD V6-4.3L VIN W (1998)
5. Remove the accelerator cable bracket nuts and the bracket.
6. Remove the throttle body retaining bolts or studs.
7. Remove the throttle body assembly.
8. Remove the flange gasket.
9. Discard the flange gasket.
INSTALLATION PROCEDURE
WARNING: In order to prevent damage to the sealing surfaces, carefully use sharp tools in cleaning the old gasket from the aluminum surfaces.
1. Clean the gasket surface on the intake manifold.
2. Install a new flange gasket.
3. Install the throttle body assembly.
4. Install the throttle body assembly retaining bolt or stud.
-
Tighten the throttle body attaching bolt or stud to 25 Nm (18 lb. in.).
NOTE: Make sure the throttle and cruise control linkage does not hold the throttle open. Refer to Accelerator Pedal.
5. Install the throttle and cruise control cables.
6. Install the accelerator cable bracket.
7. install the accelerator cable bracket nuts.
8. Install the IAC valve electrical connector.
9. Install the TP sensor electrical connector.
10. Install the air inlet duct and retaining nut.
-
Tighten the nut to 2.5 Nm (22 lb. in.).
11. Connect the negative battery cable.
