Envoy 2WD V6-4.3L VIN W (1998)
Suspension Strut / Shock Absorber: Service and Repair
Front Suspension Shock Absorber
REMOVAL PROCEDURE
1. Raise the vehicle. Support the vehicle with safety stands.
2. Remove the nut. Hold the shock absorber stem with a wrench while backing the nut off.
3. Remove the retainer.
4. Remove the grommet.
5. Remove the bolts.
5.1. Pull the shock absorber out of the spring from below.
5.2. The lower grommet and the retainer are on the stem.
5.3. Replace the parts as necessary.
6. Remove the nuts, if damaged or worn.
INSTALLATION PROCEDURE
1. Install the retainer and the grommet on the stem. Fully extend the stem.
2. Install the shock absorber up through the lower control arm and the spring. Insert the stem end through the hole in the upper control arm frame
bracket.
3. Install the grommet to the stem.
4. Install the retainer to the stem.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
