Envoy 2WD V6-4.3L VIN W (1998)
14. Remove the TCC solenoid valve bolts.
15. Use the J 28458 in order to remove the pass-through electrical connector from the transmission case.
Place the small end of the J 28458 over the top the connector.
Twist the J 28458 in order to release the four tat while pulling the harness connector from the transmission case.
16. Remove the TCC solenoid valve with the wiring harness from the transmission case.
INSTALLATION PROCEDURE
1. Install the Torque Converter Clutch (TCC) solenoid with the wiring harness to the transmission case.
2. Install the pass-through electrical connector to the transmission case.
3. Install the TCC solenoid bolts and screws.
4. Install the pressure control solenoid.
5. Install the pressure control solenoid retainer.
