Envoy 2WD V6-4.3L VIN W (1998)
LEAK INSPECTION POINTS
CASE POROSITY REPAIR
1. Clean the leak area with solvent.
2. Allow the area to air dry.
3. Mix a sufficient amount of epoxy adhesive, P/N 1052533, or equivalent. Follow the manufacturer's recommendations.
CAUTION: Epoxy adhesive may cause skin irritations and eye damage. Read and follow all information on the container label as provided by the
manufacturer.
4. While the transmission case is hot, apply the epoxy adhesive with a clean, dry soldering acid brush.
5. Allow the epoxy adhesive to cure for three hours before starting the engine.
6. Repeat the fluid leak diagnosis procedures in order to determine if the leak is fixed.