Envoy 2WD V6-4.3L VIN W (1998)
8. Remove the shift cable end from the steering column shift controller stud ball.
9. Remove the cable from the vehicle. Pull the cable from under the vehicle.
INSTALLATION PROCEDURE
1. Ensure that the transmission is in the mechanical neutral position.
^
Rotate the transmission control lever clockwise until it reaches the full clockwise stop position.
^
Move the shift lever counterclockwise two detents.
2. Feed the steering column end of the shift cable through the grommet hole in the floor panel of the vehicle.
3. Connect the shift cable end to the steering column shift controller stud ball.
4. Install the clip that secures the shift cable to the steering column bracket.
5. Install the shift cable to the transmission bracket.
^
Do not depress the locking tab that secures the shift cable to the transmission bracket.
Ensure that the tab remains positioned OUT.
