Envoy 2WD V8-5.3L (2007)
Emergency Contact Module: Service and Repair
OnStar Module Bracket Assembly Replacement (Trailblazer, Envoy, Rainier)
OnStar Module Bracket Assembly Replacement (Trailblazer, Envoy, Rainier)
Removal Procedure
1. Remove the right rear seat cushion.
2. Remove the communication interface module.
3. Using a flat bladed tool, release the retaining tab on the upper bracket.
4. Slide the upper bracket inboard until the retaining tabs are released from the processor bracket.
5. Remove the upper bracket from the processor bracket.
6. Remove the nut that retains the processor bracket to the rear seat back stud.
7. Remove the processor bracket from the vehicle.
Installation Procedure
1. Install the processor bracket to the rear seat studs.
Notice: Refer to Fastener Notice.
2. Install the nut to the rear seat back stud.
Tighten the nut to 45 N.m (33 lb ft).
