Envoy 2WD V8-5.3L (2007)
1. Position the fascia to the vehicle, ensuring that the body side attachment tabs are fully seated.
2. Install the 4 push-pins that retain the bottom of the fascia to the headlamp housing panel.
3. Install the push-pins (3) that retain the fascia to the fascia support rods (2).
4. Install the air defector.
5. Install the fog lamps.
6. Lower the vehicle.
Notice: Refer to Fastener Notice.
7. Install the 2 bolts that retain the top of the fascia to the headlamp housing panel.
Tighten the bolts to 10 N.m (89 lb in).
8. Install the push-pin that retains the center of the top of the fascia to the headlamp housing panel.
9. Install the grille.
