Envoy 2WD V8-5.3L (2007)
2. Install the seat back.
3. NOTE: Refer to Fastener Notice.
Install the 4 nuts that secure the seat pan to the power seat adjuster frame.
Tighten the nuts to 25 N.m (18 lb ft).
4. Install the SIR harness (2) to the seat clips (1, 4).
5. Connect the gray lumbar electrical connector (5), if equipped.
6. Connect the black electrical connector (3) to the seat belt buckle.
7. Connect the black electrical connector (6) to the seat back harness.
8. Install the seat belt buckle to the seat with the nut.
Tighten the nut to 55 N.m (41 lb ft).
9. Install the seat cushion trim panel.
10. Install the front bucket seat assembly to the vehicle.
11. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration.
