Envoy 2WD V8-5.3L (2007)
14. Remove the 3 hog rings that retain the seat back pad to the reinforcement bar located at the top of the seat back.
15. Spread the pad apart and push the cover and pad up over the seat back in order to expose the head restraint guides.
16. Remove the head restraint guides by squeezing the locking tabs together and pulling the restraint guides upward and out of the seat frame.
17. Remove the seat back cover the remainder of the way from the seat back.
18. Disconnect the electrical connector for the seat back heating element, located near the seat belt retractor, if equipped.
19. Carefully remove the seat back pad from the seat back frame.
Installation Procedure
1. Position the seat back pad to the seat back frame.
2. Connect the electrical connector to the seat back heating element, if equipped.
3. Partially install the seat back cover over the top of the seat.
4. Install the head restraint guides to the seat frame. Ensure that the locking tabs are fully seated. The guide with the release tab goes on the
right-hand side.
5. Pull the seat back cover down approximately 18 cm (7 in) from the top of the seat back, leaving the reinforcement bar exposed.
6. Install the hog rings that retain the seat back pad to the reinforcement bar.
7. Pull the seat cover over the seat back pad.
8. Press the seat cover hook and loop retaining strips together by firmly running your hand over the seat back cover.
Notice: Refer to Fastener Notice.
9. Install the seat belt bezel to the top of the seat back with the mounting screw.
Tighten the seat belt bezel screw to 3 N.m (26 lb in).
