Envoy 2WD V8-5.3L (2007)
3. Install the passenger presence system, if removed.
4. Install the seat cushion cover and pad to the seat frame.
Notice: Refer to Fastener Notice.
5. Install the 4 nuts that secure the seat pan to the power seat adjuster frame.
Tighten the seat pan mounting nuts to 25 N.m (18 lb ft).
6. Install the seat harness to the seat pan.
7. Install the SIR harness (2) to the seat clips (1, 4).
8. Connect the gray lumbar electrical connector (5), if equipped.
9. Connect the black electrical connector (3) to the seat belt buckle.
10. Connect the black electrical connector (6) to the seat back harness.
11. Install the 3 seat switch bezel mounting screws.
12. For the passenger seat, re-zero the passenger presence system.
Front Seat Cushion Cover and Pad Replacement
Front Seat Cushion Cover and Pad Replacement
Removal Procedure
1. Remove the 3 seat switch bezel screws.
2. Remove the 4 nuts that retain the seat pan to the seat adjuster assembly.
3. Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.
4. Release the J-strips (1, 3) on each side of the seat cushion.
5. Release the front/rear J-strips (2, 4).
