Envoy 2WD V8-5.3L (2007)
6. Remove the supplemental inflatable restraint (SIR) electrical harness (2) from the seat pan.
7. Remove the seat electrical harness from the seat pan.
8. Remove the wire harness fasteners from the seat pan.
9. Disconnect the seat cushion heater electrical connector, if equipped.
Important: When separating the seat cover hook and loop retaining strips, do not pull the adhesive-backed strip from the seat pad.
10. Separate the hook and loop retaining strips.
11. Remove the hog rings (1) from the bottom rear side of the cover.
12. Remove the 11 hog rings from the top side of the cover.
13. Remove the seat cushion trim cover and pad from the seat frame.
14. Remove the seat module retaining screw, if equipped.
15. Remove the seat module, if equipped.
16. Remove the seat cover from the seat cushion.
17. Remove the seat cushion from the seat pan.
Installation Procedure
1. Install the seat cushion to the seat pan.
2. Install the seat cover to the seat cushion.
3. Using a side-to-side motion, carefully pull the seat cushion cover onto the seat pan.
4. Install the seat module, if equipped.
