Envoy 2WD V8-5.3L (2007)
3. Remove the screws from the trim panel.
3. Remove the trim panel from the seat assembly.
Installation Procedure
1. Install the trim panel to the power seat by performing the following steps:
1. Align the trim panel to the seat assembly.
Notice: Refer to Fastener Notice.
2. Install the screws retaining the trim panel to the seat assembly.
Tighten the trim panel screws to 3 N.m (26 lb in).
3. Install the 3 seat switch bezel mounting screws.
Tighten the seat switch bezel mounting screws to 3 N.m (26 lb ft).
2. Install the trim panel to the manual seat by performing the following steps:
1. Install the screws in the trim panel.
2. Install the lumbar support knob.
3. Install the seat back recliner handle.
Rear Seat Cushion Replacement (TrailBlazer, Envoy, Rainier)
Rear Seat Cushion Replacement (TrailBlazer, Envoy, Rainier)
Removal Procedure
1. Remove the rear seat bracket trim cover.
2. Remove the hydraulic jack from the jack stowage area, on the left side only.
