Envoy 2WD V8-5.3L (2007)
9. Remove the brake caliper mounting bracket retaining bolts. Lower bolt shown.
10. Remove the brake caliper mounting bracket.
11. Remove the guide pin seals from the brake caliper mounting bracket.
12. Inspect the brake rotor. Refer to Brake Rotor Surface and Wear Inspection.
Installation Procedure
1. Install the guide pin seals on the mounting bracket.
2. If the guide pins and brake pad retaining clips are to be reused, use denatured alcohol to clean them.
3. Dry the brake guide pins and brake pad retaining clips with non-lubricated, filtered air.
