Envoy 2WD V8-5.3L (2007)
Important: DO NOT reuse the old copper gaskets. Use only NEW copper gaskets.
1. Install the NEW copper gaskets to the brake hose and bolt.
2. Install the brake hose bolt to the brake caliper.
Notice: Refer to Fastener Notice.
3. Install the brake hose to brake caliper.
Tighten the brake hose bolt to 44 N.m (33 lb ft).
4. Install the brake hose retaining bolt to the frame.
Tighten the brake hose bolt to 20 N.m (18 lb ft).
5. Remove the rubber cap or plug from the brake pipe fitting.