Envoy 2WD V8-5.3L (2007)
1. Install the park brake actuator lever housing to the backing plate.
2. Perform the following procedure before installing the backing plate bolts:
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
3. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
Notice: Refer to Fastener Notice.
3. Install the backing plate bolts.
Tighten the backing plate bolts to 135 N.m (100 lb ft).
4. Install the park brake shoe. Refer to Park Brake Shoe Replacement.
5. Install the axle shaft. Refer to Rear Axle Shaft Replacement.
6. Adjust the park brake shoe. Refer to Park Brake Adjustment.
