Envoy 2WD V8-5.3L (2007)
Installation Procedure
Important:
*
All gasket surfaces should be free of oil or other foreign material during assembly.
*
DO NOT reuse the valve rocker arm cover gasket.
*
The valve rocker arm cover bolt grommets may be reused.
*
If the oil fill tube has been removed from the rocker arm cover, install a NEW fill tube during assembly.
Lubricate the O-ring seal of the NEW oil fill tube with clean engine oil.
1. Insert the NEW oil fill tube into the rocker arm cover.
Rotate the tube clockwise until locked in the proper position.
2. Install the oil fill cap into the tube.
Rotate the cap clockwise until locked in the proper position.
3. Install a NEW rocker cover gasket (1) into the valve rocker arm cover.
