Envoy 2WD V8-5.3L (2007)
1. Install the air temperature actuator-left (1).
Notice: Refer to Fastener Notice.
2. Install the air temperature actuator-left retaining screws.
Tighten the screws to 1.9 N.m (17 lb in).
3. Connect the air temperature actuator-left electrical connector.
4. Install the I/P carrier.
5. Recalibrate the air temperature actuator on vehicles equipped with automatic climate control (C68). Refer to Actuators Recalibration (Primary).
See: Testing and Inspection/Programming and Relearning
Mode Actuator Replacement
Mode Actuator Replacement
Removal Procedure
1. Remove the left side sound insulator screws.
2. Remove the left hand floor duct.
3. Disconnect the electrical connector from the mode actuator.
4. Remove the screws from the mode actuator (1).
5. Remove the mode actuator.
Installation Procedure
