Envoy 2WD V8-5.3L (2007)
2. Install the condenser to the radiator bolts.
Tighten the bolts to 9 N.m (80 lb in).
3. Install the condenser LH upper bracket bolt and bracket.
Tighten the bolt to 9 N.m (80 lb in).
4. Install the studs from the condenser inlet and outlets.
Tighten the studs to 4.5 N.m (40 lb in).
5. Install the evaporator tube (4) from the condenser.
6. Install the evaporator tube nut (5) form the condenser.
Tighten the nut to 28 N.m (21 lb in).
7. Install the upper radiator support bar.
8. Install the bolts form the upper radiator support bar.
Tighten the bolts to 50 N.m (37 lb in).
9. Install the radiator diagonal base.
10. Install the head lamp housing panel.
11. Install the hood latch.
12. Connect the compressor discharge hose (2) to the condenser.
13. Install the compressor discharge hose nut (1) to the condenser.
Tighten the nut to 28 N.m (210 lb in).
14. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
15. Leak test the fittings of the components using J39400-A.
