Envoy 2WD V8-5.3L (2007)
Center Mounted Brake Lamp: Service and Repair
HIGH MOUNTED STOP LAMP REPLACEMENT (ENVOY, TRAILBLAZER, RAINIER)
REMOVAL PROCEDURE
1. Open the liftgate.
2. Lower the rear portion of the headliner by releasing the 2 headliner retaining pins.
3. Disconnect the high mount stop lamp electrical connector (2).
4. Remove the grommet (1) from the body.
5. NOTE: Do NOT raise the liftgate while the liftgate glass is open. This can result in damage to the high-mounted stoplamp, the liftgate hinges, or
the liftgate glass.
Close the liftgate.
6. Open the liftgate window.
7. Remove the 2 screws that retain the high mount stoplamp to the lift gate window reveal molding.
8. Remove the high mount stop lamp from the vehicle.
INSTALLATION PROCEDURE
1. Install the high mount stop lamp to the lift gate window reveal molding, ensuring the center retaining tab is fully seated.
2. NOTE: Refer to Fastener Notice.
Install the 2 screws that retain the high mount stop lamp to the lift gate window reveal molding.
Tighten the 2 retaining screws to 2.5 N.m (22 lb in).
3. Close the liftgate window.
4. Open the liftgate.
