Envoy 2WD V8-5.3L (2007)
Hazard Warning Flasher: Service and Repair
HAZARD AND TURN SIGNAL FLASHER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left closeout/insulator panel.
2. Remove the flasher retaining bracket from the insulator panel.
3. Disconnect the flasher from the electrical connector.
4. Remove the flasher from the vehicle.
INSTALLATION PROCEDURE
1. Position the flasher to the insulator panel.
2. Connect the electrical connector to the flasher.
3. Install the flasher retaining bracket to the insulator panel.
4. Install the left closeout/insulator panel.
