Envoy 2WD V8-5.3L (2007)
4. Install the power steering hose assembly (1) to the vehicle.
Notice: Refer to Fastener Notice.
5. Install the power steering hose assembly rear bracket (2) mounting bolt.
Tighten the bolt to 10 N.m (89 lb in).
6. Install the power steering pressure hose retaining clip.
7. Install the power steering hose assembly front bracket mounting bolt (3).
8. Install the power steering cooler hose (3) to the power steering pump (2).
Notice: Refer to Component Fastener Tightening Notice.
9. Connect the power steering pressure (1) to the power steering pump (2).
Tighten the power steering pressure hose fitting to 25 N.m (18 lb in).
10. Install the ECM to the ECM mounting bracket. Refer to Engine Control Module Replacement.
11. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.