Envoy 2WD V8-5.3L (2007)
Clean or replace the components and assemblies as required.
6. Use a clean shop towel in order to wipe off the male connection end.
7. Inspect both ends of the fittings for dirt and burrs. Clean or replace the components as required.
Installation Procedure
Caution: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine
oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
1. Apply a few drops of clean engine oil to the male connection end.
2. Push both sides of the fittings together in order to snap the retaining tabs into place.
3. Once installed, pull on both sides of the connection in order to make sure the connection is secure.
4. Install the retainers to the fuel line quick-connect fittings.
5. Install the fuel cap.
6. Connect the negative battery cable.
