Envoy 2WD V8-5.3L (2007)
10. Use the following procedure if the vehicle is equipped with 4-wheel drive (4WD):
1. Remove the front propeller shaft.
2. Remove the transfer case.
3. Support the transmission with a suitable transmission jack.
4. Remove the transmission support.
5. Lower the transmission slightly.
6. Remove the EVAP/fuel hose/pipe assembly from the retaining clips (1) on the transmission.
11. Remove the EVAP/fuel hose/pipe bracket nut (5).
12. Remove the fuel hose/pipe bracket (6) from the bellhousing stud.
13. Disconnect the EVAP pipe (2) from the fuel tank.
14. Disconnect the fuel feed pipe (1) from the fuel tank.
15. Cap the fuel and EVAP pipes at the fuel tank.
16. Remove the EVAP/fuel hose/pipe assembly from the vehicle.
Important: Note the position of the EVAP/fuel hose/pipe assembly clips prior to disassembly.
17. Remove the EVAP/fuel hose/pipe assembly retaining clips.
18. Remove the fuel feed or return pipe to be replaced from the EVAP/fuel hose/pipe assembly.
Installation Procedure
