Envoy 2WD V8-5.3L (2007)
Notice: Refer to Fastener Notice.
3. Install the sensor nut and position the sensor body parallel to the inside wheel surface while torquing.
Tighten the sensor nut to 7 N.m (62 lb in).
Important: Before reinstalling the tire on the wheel, note the following items to avoid tire pressure sensor damage upon tire mounting.
^
Position the mounting/dismounting head 180 degrees from the valve stem.
^
Position the bead transition area 45 degrees counterclockwise of the valve stem.
^
Using the tire machine, rotate the tire/wheel assembly clockwise when transferring the tire bead to the inside of the wheel rim.
^
Repeat items for outer bead.
Install the tire on the wheel. Refer to Tire Mounting and Dismounting.
Important: A service replacement tire pressure sensor is shipped in OFF mode. In this mode the sensor's unique identification code
cannot be learned into the passenger door modules (PDMs) memory. The sensor must be taken out of OFF mode by spinning the
tire/wheel assembly above 32 km/h (20 mph) in order to close the sensors internal roll switch for at least 10 seconds.
4. Install the tire/wheel assembly on the vehicle. Refer to Tire and Wheel Removal and Installation.
5. Lower the vehicle.
6. Learn the tire pressure sensors. Refer to Tire Pressure Sensor Learn.
