Envoy 2WD V8-5.3L (2007)
Suspension Strut / Shock Absorber: Removal and Replacement
Shock Module Replacement
Shock Module Replacement
Tools Required
J 36607 Ball Joint Separator
Removal Procedure
1. Remove the shock module upper retaining nuts.
Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in
premature failure of the coil springs.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
4. Loosen the shock module yoke to lower control arm retaining nut.
