Envoy 2WD V8-5.3L VIN M (2005)
10. Secure the cylinder in the J 41340.
1. Inspect that the spring retainer is facing up and positioned directly under the punch slots.
2. Push the cylinder into the J 41340 until butted with the cylinder bezel.
3. Tighten the holding screw.
11. Stake the bezel end of the retainer in place:
1. Hold the flat side of the punch, part of J 41340, squarely against the face of the cylinder bezel.
2. Stake the lock cylinder metal over the retainer corners.
12. Stake the other end of the retainer:
1. Remove the punch, part of J 41340.
2. Rotate the punch, part of J 41340, 180 degrees.
3. Hold the punch, part of J 41340, squarely against the end of the punch slot on J 41340.
4. Stake the metal over the other end of the retainer.
13. Loosen the holding screw.
14. Remove the cylinder from the J 41340.
15. Inspect that the retainer is properly staked. Restake as needed.
16. Lubricate the cylinder retainer slot.
17. Insert the following parts into the cylinder retainer slot:
*
The retainer spring (2)