Envoy 2WD V8-5.3L VIN M (2005)
1. Position the garnish molding to the liftgate.
2. Install wire harness (1) into the slot located on the garnish molding.
3. Index the locating tabs to the corresponding holes in the liftgate.
4. Index the retaining clips to the liftgate.
5. Push the garnish molding into the liftgate in order to fully seat the retaining clips.
6. Close the liftgate.
Garnish Molding Replacement - Windshield Pillar
Garnish Molding Replacement - Windshield Pillar
Removal Procedure
1. Starting at the top of the garnish molding, carefully release the upper attaching clip that retains the garnish molding to the first pillar.
2. Release the remaining 2 retaining clips from the first pillar.
3. Remove the garnish molding (1) from the vehicle.
Installation Procedure
1. Position the garnish molding (1) to the vehicle.
2. Align the locating fingers to the corresponding holes in first pillar.
3. Starting at the top of the garnish molding, seat the attachment clips that retain the garnish molding to the first pillar.
Jack and Tool Stowage Container Bracket Replacement (Envoy XUV)
Jack and Tool Stowage Container Bracket Replacement (Envoy XUV)
Removal Procedure