Envoy 2WD V8-5.3L VIN M (2005)
Tighten the rear seat cushion bolts to 11 N.m (97 lb in).
Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier)
Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier)
Removal Procedure
1. Remove the rear seat bracket trim cover.
2. Remove the hydraulic jack from the jack stowage area, on the left side only.
3. Position the seat cushion assembly in order to gain access to the 2 rear seat mounting nuts.
4. Remove the 2 mounting nuts.
5. Remove the seat cushion assembly from the vehicle.
Installation Procedure
1. Position the seat cushion assembly to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the 2 nuts that retain the seat cushion assembly to the floor panel.
Tighten the rear seat mounting nuts to 45 N.m (33 lb ft).
3. Install the hydraulic jack into the jack stowage area, on the left side only.
4. Adjust the seat cushion assembly to the latched position.
5. Install the rear mount trim cover.
Seat Cushion Trim Panel Replacement - Rear No.1 (TrailBlazer EXT, Envoy XL, Envoy XUV)
Seat Cushion Trim Panel Replacement - Rear No.1 (TrailBlazer EXT, Envoy XL, Envoy XUV)
Removal Procedure
1. Remove the seat from the vehicle.
