Envoy 2WD V8-5.3L VIN M (2005)
40.6. Install the ring terminal (orange wire) to the underhood fuse block stud (1).
40.7. Locate circuit no. 241 or 441 (ignition 3 brown wire) (PIN B11 or C11) in the existing underhood fuse block harness (1) of C2 (2) and
splice bare wire to it using a splice clip. Wrap with electrical tape.
40.8. Locate connector C105 (3), located on the left side inner fender. Separate the connector halves. On the female side of the connector, remove
the terminal from cavity F (gray/black wire) and tape back.
40.9. Install the terminal end on the pump wiring harness into cavity F of connector C105.
41.
Install the evaporator tube and nut to the evaporator.
Tighten
Tighten the nut to 28 N.m (21 lb ft).
42.
Install the coolant recovery reservoir with the accumulator attached.
43.
Install the nut and bolt securing the coolant recovery reservoir.
44.
Install the coolant hoses to the coolant recovery reservoir.
45.
Install the nut retaining the accumulator to the evaporator.
Tighten
Tighten the nut to 28 N.m (21 lb ft).
46.
Install the compressor suction hose assembly to the accumulator.
Tighten
Tighten the nut to 48 N.m (35 lb ft).